Make your furniture a little taller.
TallerFeet makes leg risers to the sizes you enter. Tell us how big the leg is and how much taller you want it. You see the riser in 3D with its price, then we print your risers and ship them to you.
Design your risers How to measure
For square, rectangular and round legs. Sold individually; most furniture needs a set of 4.
How it works
-
Measure the leg
Measure the widest part of the leg that will sit in the riser. See how to measure.
-
Choose the lift
Enter the leg size and the lift: how much taller you want the furniture. The page shows the riser in 3D, its exact sizes and the price as you change them.
-
We print and ship them
Your risers are 3D printed in PETG or PLA plastic, in the color and finish you pick, and shipped to you. US addresses only.
Made to the size you enter
Every riser is made to the size you enter. There is no size chart to squint at and no picking the closest match.
We guarantee the opening and the lift match what you ordered, within 0.5 mm or 1%, whichever is larger. If a riser is outside that, we remake it or refund it. See refunds and remakes.
In the builder you choose the plastic under Material, then a color. PETG holds steady weight best, so it carries more. PLA carries less and must stay out of sun and away from warmth. The builder shows the weight figure for each as you pick. You also choose the finish: smooth, fluted or pinstripe.
What they are good for
They also help when you want a robot vacuum to fit under furniture, or want two pieces to stand at the same height.
Leveling risers for an uneven floor
We now make leveling risers too, for furniture that stands on an uneven floor. Each one has a deeper opening and comes with four plates (1, 2, 4 and 8 mm thick) that add up to anything from 0 to 15 mm, about 5/8 in, in 1 mm steps.
Drop plates into the openings, under the low legs, until the furniture sits level. There is nothing about the floor to measure.
Before you order
- Count the people. If anyone sits or lies on the furniture, such as a bed or a sofa, their weight is part of what the risers carry. Enter the full weight, and round up.
- Not for hot appliances. Do not use them under or near stoves, ovens, heaters, grills, fireplaces or wood stoves. The plastic softens with heat, and PLA softens soonest.
- Each design shows an estimated weight it can carry. It is a cautious estimate, not a tested rating, and we do not take an order above it.
- Indoor use only. Keep them out of direct sunlight, and out of freezing or damp unheated spaces.
- Not for anything a person stands or climbs on. No ladders, step stools, bunk beds or cribs.
- You measure. We guarantee the printed size matches what you ordered. Nobody here checks your measurements, so we cannot promise a riser fits your furniture.
- Firm, flat floors. On carpet or a rug, check that each riser sits flat and the furniture is steady.
- Made after you order. Each riser is printed after you order, so it usually ships in 5 to 10 business days, often sooner. We don’t promise a delivery date; if your order hasn’t shipped within 30 days, we email you and you can cancel for a full refund.
Ready when you have a tape measure
It takes a minute. You see the price before you decide.